SURRENDER THE ME FOR THE WE
Week 14: Product sketches and design specifications
During this week, we learn about product sketches. We were tasked with drawing different types of sketching techniques. This techniques were, Circles, Curves. straight line and ellipses. We were then tasked with more advance sketches such as one point and two point perspective.
Afterwards, we were asked to draw either a one point or two point perspective of our chemical product with design specification. We draw our chemical product in a one point perspective.
We were taught on design specifications and on the importance of it and we found out the relevant specifications that are needed for product designs. The table below shows our design specifications for our chemical product.
Practical 4:
For practical 4, we were tasked to create a cardboard toy product that is targeted at children. We had to apply different cardboard techniques such as L-Brace. We were give a time limit of two hours and the end of the duration we were tasked to give a presentation to promote our toy. We face some challenges on our way and had constantly improvise throughout the practical session. At the end of the practical session, we had a voting session for the best toy. We ended up in third place.
Ol' Luck
Its a game of luck, where players are give four ping pong balls and the aim is to earn as much points as possible by dropping the four balls into the eight different holes.
'Lions don't lose sleep over the opinions of sheep'
